Photo Frame Slider Card with Elephant and Bunny

Glue a piece of backing paper onto your card blank using a glue runner, pressing down firmly to secure.

Punch two holes through the spine of the card and insert gold brads through each hole, pushing them flat on the inside.

Cut one large square from red card using your largest nesting die, then cut three slightly smaller squares from the same die.

Cut an aperture using a die that is two sizes smaller than your largest die to create the photo slot.

Cut a small notch at the bottom of the largest square to allow the photo to slide in and out.

Glue the three medium squares together in layers on top of the largest square, ensuring they are level and aligned to create depth.

Glue the aperture piece to the front as a cover, which will hide the internal mechanism and allow wiggle room for the photo.

Cut a gold frame from complementary die-cut layers and glue it around the aperture to add decorative detail.

Watercolour the elephant image with grey, adding black for depth in the trunk, forehead and legs, then add pink to the ears.

Die-cut the coloured elephant and glue it to the back panel, then attach the bunny to the balloon string to look like the elephant is holding it.

Stamp your sentiment in black ink onto the backing paper, pressing multiple times to ensure crisp coverage on the textured surface.

Thread ribbon through the punched holes and tie a bow on the front of the card.

Attach foam pads to the back of your elephant and bunny elements, then position them on the card at an angle to frame the sentiment.

Slide your chosen photo into the frame slot to complete the card.